Description
The JS RSD-400 110v (code 012-402) is the site version of the RSD-400 residue puddle pump, for contractors, flood restoration teams and hire fleets running from a 110v transformer. It drains flood water down to approximately 1 mm, delivering up to 190 litres per minute with a maximum head of 11.5 metres from a 0.4 kW motor. On 110v it draws 5.6 A, and it pumps through a 1¼” BSP female outlet with a stepped hose tail for 25 mm, 19 mm or 15 mm hose. It comes with 10 metres of power cable.
For mains sockets in a building, the RSD-400 230v is the same pump on 230v. If the water is deep, shift the bulk first with a JS heavy duty contractor pump and then finish the floor with the RSD-400.
The RSD-400 is built for professional use. The outer case, motor case and shaft are stainless steel, and the motor lid, pump casing and volute are cast iron, with a plastic impeller. Twin mechanical seals with carbon ceramic and silicon carbide faces run in a lubricated chamber, and the bottom plate is cushioned rubber so the pump does not damage tank bases or finished floors. A non-return valve on the suction side stops water running back when the pump stops. The pump has to be primed if used in shallow water.
This is a manual pump that runs whenever it is switched on. For unattended running, it can be used with a MATIC Utility 15 panel and MATIC puddle sensor, or with the Crab low level sensor; check with us that you have the 110v version of the Crab before ordering.
Features
- Drains water down to approximately 1 mm
- 0.4 kW motor, 110v single phase, 5.6 A
- Up to 190 l/min and 11.5 m head
- 1¼” BSP female outlet with 25 / 19 / 15 mm stepped hose tail
- Stainless steel outer case, motor case and shaft
- Cast iron motor lid, pump casing and volute; plastic impeller
- Twin mechanical seals (carbon ceramic and silicon carbide) in a lubricated chamber
- Non-return valve on the suction side
- Cushioned rubber bottom plate
- Maximum solids 2 mm
- Manual operation, 10 metres of power cable
Applications
- Floor slabs, basements and excavated levels on construction sites
- Flood restoration and drying-out work
- Lift pits and service shafts during fit-out
- Following a larger site drainage pump to clear the residue
- Hire fleet residue pump for 110v sites
Not for sewage, sludge, silt-laden site water or liquids containing oil or chemicals: the RSD-400 is a clean water residue pump with a 2 mm solids limit. On site, use a larger contractor pump for dirty water with grit and keep the RSD-400 for the final clean water.

The JS RSD-400 range
| Model | Supply | Outlet | Max Flow (l/min) | Max Head (m) | Motor (kW) | Current (A) | Code |
|---|---|---|---|---|---|---|---|
| RSD-400 230v | 230v | 1¼” BSP female | 190 | 11.5 | 0.4 | 2.8 | 012-400 |
| RSD-400 110v | 110v | 1¼” BSP female | 190 | 11.5 | 0.4 | 5.6 | 012-402 |
See the full JS RSD-400 residue puddle pump range for more on choosing and using these pumps.







Reviews
There are no reviews yet.